#1 20-12-2018 02:17:56

bearingtypes
Nouveau membre
Date d'inscription: 14-09-2018
Messages: 10

Custom DU-H half bushings DU Flanged Bushing China Factory

Experimental studies have shown that the limit of the contact angle of the DU Flanged Bushing is 120°. When the sliding bearing wears to this contact angle, the liquid lubrication is destroyed. Therefore, under the premise of not affecting the compression condition of the sliding bearing,DU-H half bushings the smaller the contact angle, the better. From the theoretical analysis of the frictional force distance, the friction composite bearing torque is the smallest when the contact angle is 60°. Therefore, it is recommended that for sliding bearings with a rotational speed higher than 500r/min, the contact angle is 60° and the rotational speed is lower than 500r/min. For white ptfe solid lubricant type bushing,bearing,wear plate,pad, the contact angle can be 90° or 60°.

Hors ligne

 

#2 06-08-2020 10:42:07

DylaBray
Nouveau membre
Date d'inscription: 06-08-2020
Messages: 1

Re: Custom DU-H half bushings DU Flanged Bushing China Factory

Well, that’s good information for me because I heard it for the first time and I always seek for more information. I ones used this but don’t remember where and you have assignment masters in this thing and I think you should post these kinds of things more.

Hors ligne

 

#3 12-08-2020 03:57:15

scottheflin589
Nouveau membre
Date d'inscription: 12-08-2020
Messages: 5

Re: Custom DU-H half bushings DU Flanged Bushing China Factory

I precisely had to thank you so much yet again. If your finding a Vinyl Siding Installation company, just go to the link.

Hors ligne

 

#4 30-08-2020 09:12:29

saeed20
Timide
Date d'inscription: 16-08-2020
Messages: 22

Re: Custom DU-H half bushings DU Flanged Bushing China Factory

Hors ligne

 

Pied de page des forums

Propulsé par FluxBB
Traduction par FluxBB.fr